What is the ST03 Torque protocol?Updated 5 months ago
The ST03 must be installed in the correct order and with recommended torque in order to work as intended without slipping. Please refer to the exploded view drawing linked here for instructions on where to use grease and carbon assembly paste.
- Install top cap onto stem, starting at handlebar first, then pushing down toward back of stem. The stem top should snap into place.
- Place angle pill that corresponds to your shim onto stem top. Remove any torque from stem steerer bolts. Tighten headset compression bolt with 4mm allen key, drawing system together until slop is removed from HS.
- Install flat-head screws onto top cap. Torque with 3mm allen key to 4Nm
- Align stem on the steerer tube and torque steerer bolts to 5Nm by taking each bolt slowly up to torque and going back and forth on each bolt until you are consistently getting 5Nm on both bolts.
- Install faceplate bolts (tighten just enough to keep bar from slipping easily, but still loose enough that you can adjust bar tilt)
- Rotate bar to correct location. Bring faceplate bolts up to 5Nm evenly. Once torque has been reached on one, re-check the other. Repeat this process until the torque is stable.
- Double-check that all fasteners are tight and everything is straight
After your first few rides, be sure to go back and re-check the torque on all the fasteners as things can settle in after riding.